Some more progress on the z-axis assembly. Z-Axis slider block mounting (the large curved piece attached to thread rod block and 7 mm PLA linear bearing) Will be the mounting point for a support piece for the glass build plate. Basically this support piece will come down from the Z-Axis slider block and extend under the glass plate slightly. The support piece will have adjustable bolts that raise the glass plate up or down. It will be a three point bed leveling system. I decided that the pieces will be relatively chunky. I am thinking that lower infill with larger volume will give higher strength per ratio then a smaller solid with 100 percent infill. I will experiment with this. Thats all for today!


Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s